Welcome to the official website of Foshan Xinxing Aoda Decoration Materials Co., Ltd!
Good quality, good materials, good service

Telephone:

133-9276-6365


Foshan Xinxing Aoda Decoration Materials Co., Ltd

Integrated production by manufacturers, producing excellent products

​Installation Guide for Office Partition Walls and Construction Process for Partition Walls!​

As people pursue higher standards of life, more and more people want to improve their living environment. The appearance of partition walls not only has a partition effect, but also plays a pivotal role in the overall home decoration layout. The dual advantages of practicality and beauty are highly favored. The following partition wall manufacturers introduce the construction process of wooden keel partition walls and glass brick partition walls.

1. Wooden keel partition wall

1. Construction procedures

Clean the base floor → draw lines and find the rules → use bricks and cement mortar to make floor pillows (also called skirting boards) on the ground → draw lines and return the lines to the ceiling and the walls of the main structure → erect frame wall reinforcements → install floor and ceiling ribs → erect partition purlins → nail horizontal purlins → cover the panels, reserve socket locations and install reinforcing wood → cover the panels.


2. Construction points

(1) The wooden keel frame should be made of red or white pine wood with a size of 40 mm x 70 mm. The spacing between the vertical keels is generally between 450 and 600 mm.

(2) When installing wooden planks along the ground and along the top, both ends of the planks should be extended into the brick wall by at least 120 mm to ensure that the partition wall is firmly connected to the original structural wall.

玻璃隔断厂家

2. Glass Brick Partition Wall

1. Glass bricks should be laid on a foundation reinforced with two f6-f8 steel bars. The foundation height should not be greater than 150mm, and the width should be more than 20mm greater than the thickness of the glass bricks.


2. Metal profiles shall be used at the top and both ends of the glass brick partition wall, and the width of the groove shall be 10 to 18 mm greater than the thickness of the brick.


3. When the length or height of the partition is greater than 1500mm, a steel bar shall be installed every two layers in the vertical direction (when the length and height both exceed 1500mm, two steel bars shall be installed); a steel bar shall be installed every three vertical seams in the horizontal direction. The steel bar shall extend into the notch by no less than 35mm. The height of the glass brick partition reinforced with steel bars shall not exceed 4m.


4. A sliding joint with a width of not less than 4 mm should be left between the two ends of the glass partition wall and the two wings of the metal profile, and the joint should be filled with linoleum; an expansion joint with a width of not less than 10 mm should be left between the glass partition board and the underside of the profile to avoid damage to the glass brick partition wall.


5. The top layer of glass bricks should extend into the notch of the top metal profile by 10 to 25 mm to prevent the glass bricks from being broken due to rigid compression.


6. The joints between glass bricks shall not be less than 10mm and not more than 30mm.The joints between glass bricks and profiles, and between profiles and buildings should be sealed with elastic sealant.



ABUIABAEGAAgwefBuAYokJLY7gUwswI43AE

Phone: Manager Su/13392766365

            Manager Huang/18688262188

            Manager Min/18123549390

Address: No. 41 Taixing Road, Taiping Industrial Zone, Dali Town, Nanhai District, Foshan

mailbox:897806519@qq.com

Foshan Xinxing Aoda Decoration Materials Co., Ltd. specializes in, welcome to inquire!

ABUIABAEGAAg3_vBuAYo_NrurwYwezh7

WeChat Consultation